The LAB2B ozone generator is a small aircooled
unitspecifically designed for bench use incorporating function
indicators, feed gas flow meter and variable output control.
The generator comprises of a high voltage/high frequency power
supply unit and an aircooled corona discharge module housed in
a mild steel epoxy coated enclosure.
ELECTRONIC POWER BOARD
The ozone generator incorporates a high voltage/high frequency
power board designed for either intermittent or continuous operation.
The circuitry has been specifically designed to give “fold-back”
short circuit protection and a fully variable module power supply
to electronically
control the ozone production rate.
The variation is manually adjustable by a control knob mounted
on the front panel of the unit.
The unit has been designed to operate on various
feed gasses such as dried air or oxygen and is capable of producing
concentrations up to 10% volume.
Down load operating instructions
(PDF)
|
FEATURES
Units can operate either under vacuum or at pressure
up to 10 psig.
Units can be combined to give larger ozone outputs if
required.
Operating and maintenance instructions including
performance graphs.
Full twelve months warranty and technical back-up
facilities available. QUALITY ASSURANCE AND TESTING
All products manufactured by Triogen Ltd comply with BS EN ISO 9002:94
quality assurance procedures and each generator is subjected to
the
following test procedure.
1. Power board function test.
2. Power board load test for 24 hours in 40°C test chamber.
3. Module pressure test.
4. Complete unit test for 24 hours.
5. Calibration test and output check. |